What is EVSE?

BLDC does not run on either direct AC or Direct DC supply. Its required to energized appropriate phase according to rotor position. So hall sensors are used to sense the rotor position so appropriate phase can be energized. Hall sensor convert magnetic filed to voltage and thus produce voltage at specific rotor position. So voltage output gives rotor position and utilized energizing appropriate phase. Hall sensor is three terminal device. Do not forget to watch easiest testing procedure for hall sensor explained below. Thank You Hybrid Electric Bike: BLDC HUB Motor Hall Sensor Signals Write your comment.

Here I would like to add few basic detail about this. Inverter converts fix DC voltage in to equivalent sinusoidal waveform noticeably by performance. Main idea behind this conversion is fact that sine wave has higher magnitude at its center (90 degree) and its reducing as go far from center both side (toward 0 degree and 180 degree). Thus supplying dc voltage of varying width such that it has high width around center and smaller at far from center resembles sine shape. This DC voltage can be switched from either from 0 to Vdc or from Vdc to –Vdc to produce same effect which call unipolar and bipolar technique respectively. Name unipolar is given as switched DC voltage applied to the load remain positive during positive cycle and negative during negative cycle. While in bilopar method this voltage switches in both the direction throughout the cycle. Thus bipolar method produces twice the voltage stress on load than maximum AC voltage that can be produce by the inverter. Thus unipoar method is more preferable.